BILGE-B-DRY’s Wireless Sensor: Automatic Water Removal & Smart Data Logging for Your Boat

Boat owners have always battled one enemy: unexpected water intrusion. But today’s boats don’t have to rely on guesswork, manual checks, or “I think the pump ran too long” instincts. BILGE-B-DRY Dry Bilge System’s wireless water sensor doesn’t just detect water - it automatically removes it, logs every event, and gives you visual history charts that reveal exactly what’s happening inside your bilge.

Traditional bilge pumps operate blindly—they turn on when water hits a float switch, then shut off when the water drops. But they don’t tell you when they ran and how often they ran.

BILGE-B-DRY’s wireless water sensor changes that.

When water is detected, the wireless water sensor automatically triggers your connected pump to run. This creates a closed loop safety system:
•    Water detected
•    Pump activated
•    Water removed
•    Event logged

Every water event is automatically recorded—no more guessing and no more “I think the pump ran last night.”

Through the BILGE-B-DRY Mobile App, logs include:
•    Timestamped water detection events
•    Pump activation duration
•    Recovery time after pump activation
•    Battery status and sensor health

This data becomes a powerful diagnostic tool. You can identify:

•    Slow leaks developing over time
•    Failing hoses or clamps
•    Stuffing box drips increasing
•    Rainwater intrusion patterns
•    Livewell or washdown plumbing issues
•    Pump performance degradation

Numbers are good. Charts are better.

BILGE-B-DRY converts your data logs into easy-to-read history charts that show:
•    Daily, weekly, and monthly water intrusion patterns
•    Pump cycles over time
•    Seasonal changes in bilge activity

These charts help you spot trends instantly:
•    A pump cycles more often? Something may be leaking.
•    Water spikes after rain? Your deck drains or hatches may need attention.
•    Increasing water levels during runs? Check thru hulls or transom seals.

The wireless sensor means you don’t need to run wires through tight compartments or tear apart your boat to install sensors. Once installed, you get:
•    Remote pump activation
•    Full access to logs and charts
•    Optional multi sensor monitoring for different compartments

With long term data and charts, you can:
•    Identify leaks before they become emergencies
•    Track pump health and replace it before failure
•    Understand how your boat behaves in different conditions
•    Catch problems that could normally go unnoticed for months

Whether you’re running a cabin cruiser, center console, or sailboat, BILGE-B-DRY’s wireless sensor automatic water removal and smart logging system fit seamlessly.

Common installation zones may include:
•    Engine bilge
•    Forward bilge
•    Aft compartments
•    Anchor lockers
•    Under console storage
•    Cabin floors
•    Livewell plumbing areas
If water shouldn’t be there, BILGE-B-DRY should be.

The BILGE-B-DRY wireless water sensor isn’t just about detecting water—it’s about automatically removing it, recording each event, and giving you visual insights that make you a smarter, safer boat owner.  Learn more: BILGE-B-DRY wireless water sensor technology.

Learn about the wireless sensor data charts and logs via the: BILGE-B-DRY Mobile App